<abstract xmlns="http://www.w3.org/1999/xhtml">

<p>Heavy agricultural trailers can be equipped with a three-axle chassis with a tandem axle set at the rear and one mounted on a turntable at the front. In such trailers, selection of the distribution of braking forces that meet the requirements of the EU Directive 2015/68, with regard to braking, largely depends on the type of tandem suspension used. The requirements for brake force distribution in agricultural trailers of categories R3 and R4 are described. On this basis, a methodology for calculating the optimal linear distribution of braking forces, characteristic of agricultural trailers with air braking systems, was developed. An analysis of the forces acting on a 24-tonne three-axle trailer during braking was performed for five different suspensions of the rear tandem axle. An optimization algorithm using the quasi Monte Carlo method was described, on the basis of which a computer program for selection of the linear distribution of braking forces was developed. The calculations were made for an empty and loaded trailer with and without the weight of the tandem suspension. The most uniform distribution of braking forces was obtained for two leaf spring with dynamic equalization and air suspension, in which the ratio of the braking force of the tandem axle and the total braking force varied between 22.9% and 25.5% for the different calculation variants. A large variation in the braking force distribution was achieved for the two leaf spring suspension, in which the ratio of tandem axle braking force and the total braking force ranged from 2.7% to 6.4% for the leading axle and from 27.8% to 36.2% for the trailing axle. The presented calculation methodology can be used in the initial phase of the design of air braking systems for three-axle agricultural trailers.</p>
</abstract>

Heavy agricultural trailers can be equipped with a three-axle chassis with a tandem axle set at the rear and one mounted on a turntable at the front. In such trailers, selection of the distribution of braking forces that meet the requirements of the EU Directive 2015/68, with regard to braking, largely depends on the type of tandem suspension used. The requirements for brake force distribution in agricultural trailers of categories R3 and R4 are described. On this basis, a methodology for calculating the optimal linear distribution of braking forces, characteristic of agricultural trailers with air braking systems, was developed. An analysis of the forces acting on a 24-tonne three-axle trailer during braking was performed for five different suspensions of the rear tandem axle. An optimization algorithm using the quasi Monte Carlo method was described, on the basis of which a computer program for selection of the linear distribution of braking forces was developed. The calculations were made for an empty and loaded trailer with and without the weight of the tandem suspension. The most uniform distribution of braking forces was obtained for two leaf spring with dynamic equalization and air suspension, in which the ratio of the braking force of the tandem axle and the total braking force varied between 22.9% and 25.5% for the different calculation variants. A large variation in the braking force distribution was achieved for the two leaf spring suspension, in which the ratio of tandem axle braking force and the total braking force ranged from 2.7% to 6.4% for the leading axle and from 27.8% to 36.2% for the trailing axle. The presented calculation methodology can be used in the initial phase of the design of air braking systems for three-axle agricultural trailers.

Calculation of the Optimal Braking Force Distribution in Three-Axle Trailers with Tandem Suspension

Acta Mechanica et Automatica

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Heavy agricultural trailers can be equipped with a three-axle chassis with a tandem axle set at the rear and one mounted on a turntable at the front. In such...

Calculation of the Optimal Braking Force Distribution in Three-Axle Trailers with Tandem Suspension

Publié en ligne: 16 mai 2022

Pages: 189 - 199

Reçu: 08 févr. 2022

Accepté: 16 mars 2022

DOI: https://doi.org/10.2478/ama-2022-0023

Mots clés
agriculture trailer, tandem axle, air braking system, braking force distribution, optimization

© 2022 Zbigniew Kamiński, published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Calculation of the Optimal Braking Force Distribution in Three-Axle Trailers with Tandem Suspension

Publié en ligne: 16 mai 2022

Pages: 189 - 199

Reçu: 08 févr. 2022

Accepté: 16 mars 2022

DOI: https://doi.org/10.2478/ama-2022-0023

Mots clésagriculture trailer, tandem axle, air braking system, braking force distribution, optimization

© 2022 Zbigniew Kamiński, published by Sciendo

This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.

Mots clés
agriculture trailer, tandem axle, air braking system, braking force distribution, optimization